Product ID:POLYURETHANE SLOW REDUCER, 1600-03
MSDS Date:06/15/1995
FSC:8010
NIIN:00N056192
MSDS Number: CDKZC

CARDINAL INDUSTRIAL FINISHES

1329 POTRERO AVE
SOUTH EL MONTE, CA 91733
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 818-444-9274

Preparer: BOB SYPOWICZ

Cage: 65860

CARDINAL INDUSTRIAL FINISHES

SOUTH EL MONTE, CA 91733 US

Telephone: 818-444-9274 OR 213-283-9335

Cage: 65860

HEXYL ACETATE; (ACETIC ACID, ESTER WITH C6-RICH

CAS: 88230-35-7

Fraction By Weight: 40%

OSHA PEL N/K

ACGIH TLV: N/K

ACETIC ACID, BUTYL ACETATE; (N-BUTYL ACETATE) (CERCLA) VP

CAS: 123-86-4

RTECS: AF7350000

Fraction By Weight: 60%

OSHA PEL 150 PPM

ACGIH TLV: 150 PPM/200STEL

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE IRRIT & REDNESS,
TEARING/BLURRED VISION. SKIN: MODERATE IRRIT POSSIBLE FROM
PROLONGED EXPOSURE, DEFATTING & DERMATITIS. INHAL: NASAL IRRIT,
HEADACHE, DIZZINESS, NAUSEA, WEAKNESS/VOMITI NG, LOSS OF
CONSCIOUSNESS. INGEST: GI IRRITATION, HEADACHE, DIZZINESS, NAUSEA,
WEAKNESS. (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: PAINT AND SOLVENTS HAVE BEEN LINKED
TO LIVER ABNORMALITIES, KIDNEY AND LUNG DAMAGE.
Medical Cond Aggravated by Exposure:PREEXISTING RESPIRATORY CONDITIONS,
PREEXISTING SKIN DISORDERS, LIVER AND KIDNEY DISORDERS.

First Aid:EYES: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. GET MEDICAL
ATTENTION IMMEDIATELY. SKIN: WASH EXPOSED AREA WITH SOAP AND WATER.
REMOVE CONTAMINATED CLOTHING. INHALATION: REMOVE TO FRESH AIR. IF
BREATH ING IS DIFFICULT, ADMINISTER OXYGEN. IFBREATHING HAS
STOPPED, GIVE ARTIFICIAL RESPIRATION. GET MEDICAL ATTENTION.
INGESTION: DO NOT INDUCE VOMITING. KEEP PERSON WARM AND QUIET. GET
MEDICAL ATTENTION.

Flash Point Method:TCC
Flash Point:72.0F,22.2C
Lower Limits:1.0%
Upper Limits:8.0%
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER FOG.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:CONTAINERS MAY DEFORM OR EXPLODE WHEN
EXPOSED TO EXTREME HEAT. DECOMPOSITION PRODUCTS MAY YIELD OXIDES OF
CARBON AND NITROGEN.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. ABSORB LIQUID
IN ABSORBENT MATERIAL AND PREVENT SPREADING TO GROUND WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:CONTAINERS OF THIS MATERIAL MAY BE
HAZARDOUS WHEN EMPTIED.
Other Precautions:SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUALS
(VAPOR, LIQUID, AND/OR SOLID), ALL HAZARD PRECAUTIONS IN THIS DATA
SHEET MUST BE OBSERVED.

Respiratory Protection:IF TLV/ANY COMPONENT IS EXCEEDED, A NIOSH APPRVD
AIR SUPPLIED RESP IS ADVISED IN ABSENCE OF ENVIRON CTL. OSHA REGS
ALSO PERMIT OTHER NIOSH APPRVD RESPS UNDER SPECIFIED CNDTNS (SEE
YOUR SFTY EQUIP SUPP LIER). ENGINEERING OR (SUP DAT)
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:CHEMICAL & SOLVENT RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EMER EYEWASH & DELUGE SHOWER .
SPLASH APRON SUGGESTED FOR MIXING OPERATIONS (CONSULT YOUR (SUP
DAT)
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING RESTROOM,
SMOKE IN SMOKING AREAS ONLY.
Supplemental Safety and Health
RESP PROT: ADMINISTRATIVE CTLS SHOULD BE IMPLEMENTED TO REDUCE EXPOS.
OTHER PROT EQUIP: SFTY EQUIP SUPPLIER). PVNT RPTD/PRLNG SKIN CONT
BY USING GB PROT HAND CREAM. WEAR IMPERVIOUS CLTHG & CHEM RESIST
BOOTS.

Boiling Pt:B.P. Text:>260F,>127C
Vapor Pres:8.3 @ 20C
Vapor Density:HVR/AIR
Spec Gravity:0.88
VOC Pounds/Gallon:878
VOC Grams/Liter:7.33
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER
Percent Volatiles by Volume:100

Stability Indicator/Materials to Avoid:YES
NONE.
Stability Condition to Avoid:EXTREME TEMPERATURES.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:DESTROY BY LIQUID INCINERATION IN ACCORDANCE
WITH APPLICABLE REGULATIONS. CONTAMINATED ABSORBENT SHOULD BE
INCINERATED OR SENT TO AN APPROVED LANDFILL IN ACCORDANCE WITH
LOCAL, STATE, AND FEDERAL REGU LATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.